hi, i have recently decided to take the hard drive (120GB - MAXTOR) our of my external hard drive and put it in my PC instead, and plave my smaller (40gb) hard drive into the external hard drive.
i switched them and now when i turn my PC on and it loads the PC status screen (where you press F1 to continue or DEL to enter setup configeration)
and it says i do not have a primary slave, but i have set this hard drive to slave (no jumper - but there is still 1 which covers 1 pin - but i tink this is permanent cos i didnt want to break it trying to get it off)
will i need to download drivers to get it to work or anything
i always thoguht you just plugged it in an it would work, which sounds stupid now that i type it
/ –
