Finally got a reply from Asus:
quote:
Originally posted by Asus tech support
kindlty note this memory is not running on default voltages (1,8v for DDR2),
although higher voltaged memory can be faster then normal voltage RAM, it is not
specifically recommended.
Please do a CMOS reset first (disconnect power from the board and place your BIOS
battery upside down in the socket for at least 30 secs and place it back), then try
the following suggestions;
Kindly check if the memory requires specific timings settings (usually on the
package of the memory) and check if the motheboard's BIOS can provide these
settings. I would also check if the memory gives the same errors when you only use 1
or 2 banks and swap them over with another 1 or 2 you have.
We could be focussing on a RAM problem to much, also a badly connectted or defective
VGA card or !
CPU could cause similar symptoms.
with kind regards, met vriendelijke groet,
TSD@Asus
Will try the things i didn't do yet they suggested tomorrow, but guess it will end up in RMA. Almost got used to using singlemonitor laptop
.
/ 
