It's basically the same, IDE (Integrated Drive Electronics) is an ATA interface and Serial ATA (Advanced Technology Attachment) is just an evolution of the first one, it's like IDE2.
quote:
SATA:
In computer hardware Serial ATA (also SATA or S-ATA) is a computer bus primarily designed for transfer of data to and from a hard disk. It is the successor to the legacy Advanced Technology Attachment (ATA a.k.a. IDE) standard, now known as Parallel ATA.
First-generation Serial ATA interfaces have a bandwidth of 150 megabytes per second, only slightly higher than that provided by the fastest PATA mode, UDMA-133. However, while further increasing PATA bandwidth is somewhat impractical, the relative simplicity of a serial link and the use of LVDS should allow SATA to scale easily. Serial ATA II (2005) will double throughput to 300 MB/s, and 600 MB/s is planned for around 2007. Still, the need for such a high speed interface could be debated; the (rarely reached) maximum transfer rates of the fastest magnetic hard drives are well under 100 MB/s, and any additional bandwidth benefits only transfers from the disk's cache.
Physically, the cables used are the largest change. The data are carried by a light and flexible seven-conductor wire with 8 mm wide wafer connectors on each end. It can be anywhere up to one meter long. Compared to the short (18 inch, 45 cm) ungainly 40 or 80 conductor ribbon cables of parallel ATA this will come as much relief to system builders. In addition, airflow and therefore cooling in equipment will be improved. Serial ATA drops the master/slave shared bus of PATA, giving each device a dedicated cable and dedicated bandwidth. The connectors are keyed -- it should no longer be possible to install cable connectors upside down.
The Serial ATA standard also specifies a power connector sharply differing from the four-pin Molex connector used by PATA drives and many other computer components. Like the data cable, it is wafer based, but its wider fifteen-pin shape should prevent confusion between the two. The seemingly large number of pins are used to supply three different voltages if necessary -- 3.3 V, 5 V and 12 V. The same physical connections are used on 3.5 inch and 2.5 inch (notebook) hard disks.
Features allowed for by SATA but not by PATA include hot-swapping and command queueing.
To ease their transition to Serial ATA, many manufacturers have produced drives which use controllers largely identical to those on their PATA drives and include a bridge chip on the logic board. Bridged drives have a SATA connector, may include either or both kinds of power connectors, and generally perform identically to native drives. They may, however, lack support for some SATA-specific features. As of 2004, all major hard drive manufacturers produce either bridged or native SATA drives.
Btw, visit
http://en.wikipedia.org every now and then
/ 
![[Image: 1-0.png]](http://tsdme.nl/yass/image/1-0.png)
, tnx